Characteristics of the modules:
Its construction is craft, molded in resin polyester
and fiberglass, with structural reinforcements of
wood, plate cellulose perforated and metallic
inserts in the holes where they lodge the tensors
and latches.
Figura 1:
The individual perforated as indicates the fig. 1
he permits to mount the horizontal and vertical
plates combining positions. This characteristic
facilitates the assembly of the forms in the
vertical growth of the wall.
The armed one of the forms is carried out mounting the two expensive al same
time, being convenient the beginning since a corner, although is not
indispensable.
It is installed simply supporting on plate,
slab or beam of chained. The same one should be executed with precision
therefore the mounted does not admit large waves in the base of support.
Due to its scarce weight is advisable in case of to be filled with SSL to place
an elastic element between the forms and the element of support (thickness
polyethylene foam tape 5 mm) to avoid filtrations. Also it is convenient and aid
al sealed the employment of tensors for the aligned instead of struts, effects
of suppression are counteracted. The precision of production gives as a result
in the assembly an effect of alignment for which themselves not rules are
employed “alienators “for this task, good results are achieved with alone to
adjust adequate the tensors stabilizing.Crecimiento vertical:
Figura 3:
After it forged in the backfill they withdraw the vertical plates (2400 mm x 600
mm) and they are mounted again on the plates (2400 mm x 150 mm) horizontal, thus
grows itself vertical as many times be necessary being able to repeat the
operation each 24 hours.
Module/Weight/Charge capacity/Strain
